Jayson offers both Standard and Comprehensive Service Plans for all oil/gas heating and electric air conditioning needs.
Our STANDARD PLAN includes Spring and Fall tune-ups and Summer/Winter adjustments, as well as all emergency service calls that may be necessary at any time during the year for your oil/gas burner or air conditioner and controls.
Standard Plan for Oil Heating
Overhaul of burner
Flush low water cutoff
Clean fuel pump and regulate pressure
Check expansion tank and water circulator
Oil all motors
Test and adjust all burner electrical equipment and controls
Inspect oil filter, lines and connections
Clean furnace and flue pipe to chimney
Check and seal air leaks around furnace door and base
Regulate oil burner for maximum efficiency and economy
Inspect and adjust blower
Standard Plan for Gas Heating
Clean and adjust thermostat
Clean air filter
Clean and adjust safety controls
Check flue pipe
Clean burners and controls
Shut down central air conditioner
Clean and adjust pilot assembly
Turn exposed dampers to heating position if market (no balancing)
Adjust burner for efficiency
Check total performance and operating efficiency of heating system
Lubricate all moving parts
Check belt and adjust tension
Standard Plan for Cooling Systems
Check operating pressures with gauges
Check belt and adjust tension
Check voltage and amperage to all motors with meter
Clean air filter
Check air temperature drop across evaporator
Check electrical lockout circuits
Check for adequate refrigerant charge and possible leaks
Check starting contractors
Lubricate all moving parts
Check all wiring and connections
Clean and adjust thermostat
Check air temperature across condenser
Check that condensate drain is open
Turn exposed dampers to cooling position if marked (no balancing)
Our COMPREHENSIVE PLAN includes tune-up and adjustment, all emergency calls and the repair or replacement of defective parts that malfunction through normal wear. We cover the following parts:
Comprehensive Plan for Parts Oil Heating
Aquastat, standard type
Ignition assembly
Primary relay control
Bellows
Igniter holder
Pump gasket
Cadmium cell & relay
Nozzle
Stabilizer
Draft regulator
Oil burner couplings
Stack relay
Fuel oil pump
Oil burner motor
Stackswitch
Fuel oil strainer
Oil burner switches
Water gauge glass
Thermostat (non-clock)
Porcelain electrodes
Ignition transformer
Fuel oil filter, cartridge
Pressuretrol
Comprehensive Plan for Parts Gas Heating
In-warranty heat exchanger
Thermocouple
Base switch
Standard gas valve
Fan control
Safety pilot
Thermostat (non-clock)
Limit control
Pressure regulator
Motor pulley
Blower pulley
Blower shaft
Emergency safety switch
Pilot burner
Run capacitor
Blower motor
Transformer
Pressure & attitude gauge
Fan belt
Draft & inducer components
Aquastat standard type
Blower wheel
Dual valve
Pressure relief valve
Blower bearing
Pop safety valve
Pressure reducing valve
Comprehensive Plan for Parts Cooling Systems
In-warranty compressor
Low pressure control
Transformer
Condenser fan motor
Time delay devices
Blower motor
Condenser fan blade
Start capacitor
Blower wheel
High pressure control
Compressor contractor
Expansion valve
Thermostat (non-clock)
Motor & blower pulleys
Blower bearings
Run capacitors
Fan relay
Blower shaft
Start relay
Fan belt
“I am very impressed with the quality of the work, and I feel your pricing was very reasonable, especially considering the professional and courteous service, including careful consideration of our carpeting and furnishings in a difficult furnace installation. I will be happy to refer The Jayson company any time.” – Livingston Customer
